Sony PVM-2030 - Connectors Overview

Connectors
—
[T]
SYNC
ON
GREEN
select switch
—
[T]
CMPTR (computer)
connector (25-pin, D-sub)
CONTROL S connectors
75ohm termination
switch
VIDEO IN connector
(BNC type)
VIDEO
OUT connector
(BNC type)
AUDIO L/R IN
jacks (phono
jack)
AUDIO UR
OUT jacks
(phono jack)
Q]
SYNC ON
GREEN
select switch
When an RGB
input source is connected
to CMPTR
connector, set
this switch to:
ON to
synchronize
with the
sync signal on G-signal.
OFF to
synchronize
with HJV.
sync signal or
composite
sync
signal.
[U
CMPTR (computer)
connector (25-pln, D-sub)
Connect to
a
microcomputor with digital or analog RGB
outputs.
For
the pin
assignment, refer to SPECIFICATIONS.
[3]
CONTROL S
IN/OUT connectors
Connect to
the
CONTROL
S
connectors of
a VTR or
several
monitors.
It is then possible to
control the system with
a
single
Remote
Commander.
m
LINE A/LINE B
VIDEO
IN connector (BNC type)
AUDIO L/R IN
jacks (phono
Jack)
Connect to the
video and audio
outputs
of
a
VTR or
a
camera
VIDEO
OUT connector
(BNC
type)
AUDIO
L/R OUT
Jacks
(phono
Jack)
Loop-through outputs
of the
IN connector and
Jacks.
Connect to the
video and audio inputs of
another
monitor.
75-ohm termination
switch'
When only
the VIDEO IN connector is
used
(nothing is
connected to
the VIDEO OUT connector), set this switch
to
ON.
When both
connectors are
used together for a loop-
through
connection), set this switch to OFF.
7