— 6 —
3. MODEL NAME SETTING METHOD WHEN ENGINE IS REPLACED
Required equipment:
• Remote controller (RMT-D245P/D246P/D247P)
• Service remote controller (J-6090-203-A)
• Monitor
Model name delete method
1. Turn the main POWER ON.
2. Press the following buttons on the service remote controller in this order.:
“ESC” k “CHAP” k “1”
* Confirm that the above operation is performed in the state that the screen has exited all settings such as “Home Menu” or “Simple
Setting”.
3. Turn the main POWER OFF.
4. Turn the main POWER ON. (The screen as shown in Fig. 1 appears.)
5. Select “2” on the screen by using the service remote controller.
* If “1” is selected on the screen, the machine will not work at all. Be sure to select “2”.
6. Find out the tentative model name from the Correspondence Table (Table 1) for the client machine. Then, enter the 4-digit “Input No.”
on the screen using the service remote controller.
7. The model name setting method is complete. (Screen disappears.)
* Upon completion of the model name setting, be sure to press both “ENTER” and “3” simultaneously on the service remote controller
without fail. It sets the remote control code “3”.
Fig.1 S-company/P-company selection
Table1 Correspondence table between tentative model name and final product name
[Recorder's Model Setting]
Input the number using the remote for Service
>?
Input No. Manufacturer
[ 1 : P ]
[2:S ]
Model name
Tentative model name
AEP1 AEP2 AEP3 UK
RDR-GX350 MRX-1600/EC1 MRX-1600/EC2 — MRX-1600/CEK
RDR-HX650 MRX-1620/EC1 MRX-1620/EC2 MRX-1620/EC1 —
RDR-HX750 MRX-1635/EC1 MRX-1630/EC2 — MRX-1635/CEK
RDR-HX950 MRX-1655/EC1 MRX-1650/EC2 ——
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
Need help?
General
