5. Schematic Diagrams
5-25-1
5-1 S.M.P.S (VCR Front Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-3
5-2 Power (VCR Front Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-5
5-3 Logic (VCR Front Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-7
5-4 ATSC TM & Connector (VCR Front Main PCB) - - - - - - - - - - - - - - - - - - - 5-9
5-5 MPEG Decoder (DVD Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-11
5-6 A/V Decoder (DVD Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-13
5-7 In Out (DVD Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-15
5-8 DV & HDMI (DVD Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-17
5-9 Front Panel (Function Timer PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-19
5-10 Function & Jack (VCR Front Main PCB) - - - - - - - - - - - - - - - - - - - - - - - 5-21
RDR-GX355
Note
For schematic Diagram
- Resistors are in ohms, 1/8W unless otherwise noted.
Special note :
Most semiconductor devices are electrostatically sensitive and therefore require the special handling techniques described under the
“electrostatically sensitive (ES) devices” section of this service manual.
Important safety notices :
Components identified with the mark 0 have the special characteristics for safety. When replacing any of these components.
Use only the same type.
To Next Page
Loading...
Need help?
General
