Sony RMT-DS11 - Service Notes; Section 5: Adjustments; 1. Before Starting Adjustment Procedures; 1-1. Adjusting Items When Replacing Main Parts and Boards

– 5 –
1. NOTE FOR REPAIR
Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
When remove a connector, don’t pull at wire of connector.
It is possible that a wire is snapped.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some pieces of
gilt may be left inside)
When installing a connector, don’t press down at wire of connector.
It is possible that a wire is snapped.
SERVICE NOTE