SA-WCT800
7
2-3. SUB-MAIN BOARD
3 Remove the cable from
the wiring stopper.
2 connector
(CN7010)
1 FFC 24P
(CN7406)
8 two screws
(BVTP3 u 8)
5 two screws
(BVTP3 u 8)
5 screw
(BVTP3 u 8)
6 wiring stopper block
5 screw
(BVTP3 u 8)
9 heat sink (main)
Note 4:
When installing the heat sink (main),
spread the compound referring to
“SPREADING OF COMPOUND”
on page 4.
4 connector (CN7201)
Note 2:
Before connect this connector,
refer to “CAPACITOR
ELECTRICAL DISCHARGE
PROCESSING” on page 3.
OK
NG
:LUHVHWWLQJ
This side is the
terminal side.
There is a gap between
cable and heat sink.
cable
heat sink
heat sink
heat sink
Cable comes in contact
with the heat sink.
cable
Note 3:
Fix the cable so that
it does not come in
contact with the heat
sink.
7 Remove the SUB-MAIN board block
in the direction of the arrow.
rear side
top side
wiring stopper
hole
hole
rib
rib
0 SUB-MAIN board
Note 5:
When installing the SUB-MAIN board,
align the two ribs and two holes.
Note 1: When the SUB-MAIN board is replaced, refer to “WIRELESS
CONNECTION (LINK) WORK OF BAR SPEAKER AND
SUBWOOFER” and “SPREADING OF COMPOUND” on
page 4.
To Next Page
Loading...
