11
GB
Joining Multiple Speakers Together
This section describes the procedure to join multiple speakers together.
Note
• When joining the speakers with the attached speaker grille facing down, take a shock-absorbing measure, for example placing the
speakers on their packaging materials (Styrofoam packing materials), in advance.
1
Attach the metal joint fitting for attaching a safety wire and a safety wire (commercially available) to
either end of the rear surface of the speaker with a 4×10 screw with washer.
Tightening torque: 2.0 N·m
Note
• Depending on the region of your residency, it may be required by law to employ, at the time of installation, multiple measures
to protect the speaker from falling off. When multiple measures are not required, however, it is still recommended that a safety
wire be used for a measure to enhance safety.
Check an installation site, an installation procedure, and tools for compliance with the building standards and regulations
before installation.
For details, follow the instructions provided by the manufacturer of the safety wire.
To Next Page
Loading...
