Sony SLS-1A - Page 47

23
GB
Low-frequency Beam
Control Limit
1.25 kHz 630 Hz 400 Hz 315 Hz 250 Hz 200 Hz
Enclosure type
Bass reflex type
Driver
Flat and Square speaker unit, 35 mm × 35 mm (1
7
/16 in × 1
7
/16 in) Full range × 8
Magnetic shielding
No
Dust and water
resistant
No
Amplifier Channels /
Rated Power
Power Output (rated)
10 W × 8 channels (at 6 ohms, 1 kHz, 1% THD)
Amplifier type
Class-D
Protection circuit
Speaker processing: Clipping limit
Amplifier: Short circuit protection/Overheat protection/Over voltage protection/
Under voltage protection/DC protection
Power unit: Overload protection/Overheat protection
Electric performance
Power (AC) Voltage
Universal
AC 100 V - 240 V, 50 Hz/60 Hz
Power (AC) Connector
IEC60320-C7
Power Consumption
87 W/Standby 7 W (Dante IN or Dante OUT: 1 port), 8 W (Dante IN and Dante OUT: 2 ports)
Input/Output
Analog Audio Input
Euro type terminal block (Pitch 3.81 mm, 3-pin, Green)
Analog Audio
Maximum Input Level
(4 stages)
Balance connection: +8.2 dBu (2 Vrms)/+12 dBu/+18 dBu/+24 dBu
Unbalance connection: +8.2 dBu (2 Vrms)/+12 dBu/+18 dBu
Input Sensitivity
(4 stages)
Balance connection: +8.2 dBu (2 Vrms)/+12 dBu/+18 dBu/+24 dBu
Unbalance connection: +8.2 dBu (2 Vrms)/+12 dBu/+18 dBu
Input Impedance
Balance connection: 94 kΩ / Unbalance connection: 47 kΩ
Digital Audio Inputs
1-channel of Dante digital audio network (RJ-45)
*8-channel of Dante digital audio network (RJ-45) is possible
Digital Audio Outputs
1-channel of Dante digital audio network (RJ-45)
*8-channel of Dante digital audio network (RJ-45) is possible
Power (DC) Input/
Output
Euro type terminal block (Pitch 5.08 mm, 4-pin, Black/Green)
DIP Switch
Select preset beam setting and Dante input channel (1ch/8ch)
Integrated DSP
A/D and D/A
Converters
24-bit, 96 kHz
FIR Filter Support
1 024 tap @ 96 kHz
Audio Latency
13 ms