Sony SRF-M903 - Clock Setting; Battery Replacement

ET RS eae i
SEE ee B
Insert two RO3 (size AAA) batteries with correct
polarity. When you insert the batteries for the first
time, 0:00 flahes in the display window. To stop
flashing, press ENTER/CLOCK.
Battery replacement
When the batteries become weak, the radio is
turned off, the time indicator appears and (i flashes
in the display window. (The sound may become
weak or distorted before <0 starts flashing.) If you
turn on the power again, you can listen to the radio
for a short time. But the power will be soon turned
off and Cul flashes again.
When i flashes, replace both batteries with new
ones. Even after you replace the batteries, cG
remains flashing. To turn off Sa, press AUTO
OFF/POWER.
Replace the batteries within about 60 seconds
after turning off the power.
If more than 60 seconds has passed, the preset
stations are canceled and the time ‘indicator
becomes 0:00.
In this case, perform the clock setting and preset
tuning again.
Notes on the battery
Insert the batteries with correct polarity.
* Do not mix new and used batteries.
¢ The batteries cannot be charged.
* To avoid damage from possible battery leakage,
remove the batteries when the unit will not be
used for a long time.
* Concerning the battery life, see ‘‘Specifications’’.
R03 (size AAA) batteries
with correct polarity
R03 (formato AAA) con
la corretta polarita
Clock Setting
1. While keeping ENTER/CLOCK pressed, press
TUNE/TIME SET + or — button until the
display shows the current time.
Press + to increase or — to decrease the digits.
When you keep the button pressed, the digits
change rapidly.
While setting the time, : is flashing.
midnight 0:00 =
0 = noon
12:0
Fs talnt =»
EAU
2 When the display shows the current time,
release ENTER/CLOCK.
: stops flashing and the clock starts operating.
To set clock to the second
After adjusting the time, keep ENTER/CLOCK
pressed. Release ENTER/CLOCK by using the time
signal.
SRF-M903