1
Ver 1.1 2003. 04
SERVICE MANUAL
US Model
Canadian Model
AEP Model
UK Model
E Model
Australian Model
SA-VE345
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
with 8 ohm loads, from 20 – 200 Hz; rated
120 watts per channel minimum RMS power,
with no more than 0.8% total harmonic
distortion from 250 milliwatts to rated
output.
SS-V345 (front and surround speakers)
Speaker system Full range, magnetically
shielded
Speaker units 5.5 × 11 cm
(2 1/4 × 4 3/8 in.), cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 110 watts
Sensitivity level 85 dB (1 W, 1 m)
Frequency range 120 Hz – 20,000 Hz
Dimensions (w/h/d) Approx. 85 × 152 × 112
mm (3 3/8 × 6 × 4 1/2 in.),
including front grille
Mass Approx. 850 g
(1 lb 14 oz) each
SPECIFICATIONS
SS-CN345 (center speaker)
Speaker system Full range, magnetically
shielded
Speaker units 5.5 × 11 cm
(2 1/4 × 4 3/8 in.), cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 110 watts
Sensitivity level 85 dB (1 W, 1 m)
Frequency range 90 Hz – 20,000 Hz
Dimensions (w/h/d) Approx. 300 × 81 × 122
mm (11 7/8 × 3 1/4 × 4 7/8 in.),
including front grille
Mass Approx. 1100 g (2 lb 7 oz)
SA-WMS345 (subwoofer)
Speaker system Active subwoofer,
magnetically shielded
Speaker unit Woofer: 20 cm (8 in.),
cone type
Enclosure type Advanced SAW type
Reproduction frequency range
26 Hz – 200 Hz
Amplifier section
Continuous RMS power output
120 W (US, CND model)
110 W (AEP, UK, AUS,
SP, MY model)
(8 ohms, 20 Hz – 20 kHz,
0.8% THD)
• SA-VE345 consists of the following models respectively.
Sony Corporation
Home Audio Company
Published by Sony Engineering Corporation
9-877-088-02
2003D0400-1
© 2003. 04
MICRO SATELLITE SYSTEM
SA-VE345/WMS345/
SS-CN345/V345
Active Subwoofer SA-WMS345
Front and Surround Speakers SS-V345
Center Speaker SS-CN345
SA-WMS345
Inputs
LINE IN (input pin jack)
SPEAKER IN (input terminals) (US, CND model only)
Outputs (US, CND model only)
SPEAKER OUT (output terminals)
General
Power requirements
US, CND model: 120 V AC, 60 Hz
AEP, UK model: 220 – 230 V AC, 50/60 Hz
AUS model: 220 – 240 V AC, 50/60 Hz
SP, MY model: 110 – 120/220 – 240 V AC,
50/60 Hz
Power consumptions 90 W
1 W (standby mode)
Dimensions (w/h/d) Approx. 230 × 392 × 464
mm (9 1/8 × 15 1/2 × 18 3/8 in.),
(US, CND model)
Approx. 230 × 392 × 447
mm (AEP, UK, AUS, SP,
MY model)
including front grille
Mass Approx. 13.2 kg (29 lb 2 oz)
SS-CN345SS-V345
– Continued on next page –
To Next Page
Need help?
General
