Sony STR-D511 Service Manual

___SIRDoI1/D611
SERVICE MANUAL
This photo is STR-D611.
mm ALi VIEG CONTROL CENTER
US Model
Canadian Model
UK Model
Australian Model
STR-D511/D611
AEP Model
STR-D611
SPECIFICATIONS
(For US and Canadian models)
PANU To [fom axel -l mney olen i fers] Ue) aT)
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
With 8-ohm load, both channels driven,
from
40
-
20,000
Hz,
rated
70
watts
(STR-
D611) or 50 watts (STR-D511) per channel
minimum RMS power, with less than 0.8%
total harmonic distortion from 250
milliwatts to rated output.
SUR (surround) MODE (8 ohms, less than 0.8% total harmonic
distortion)
STR-D511
STR-D611
FRONT 80 W/CH
CENTER (only in the 20 W 10 W
DOLBY mode)
70 W/CH
REAR 10 W
Other Specifications
Amplifier section
Continuous RMS power output (8 ohms, at 40 Hz - 20 kHz less than
0.8% total harmonic distortion) (FRONT)
STR-D611: 75 W + 75 W
STR-D511: 55 W + 55 W
Dynamic power (at 1 kHz IHF) (FRONT)
STR-D611: 90 W + 90 W (8 ohms), 120 W + 120 W (4 ohms)
STR-D511: 80 W + 80 W (8 ohms), 110 W + 110 W (4 ohms)
Harmonic distortion
Less than 0.8% at rated output
Frequency response
PHONO: RIAA equalization curve 0.5 dB
CD
VIDEO 10 Hz - 50 kHz +1 dB
TAPE
Inputs
Sensitivity Impedance | S/N (weighting
network, input level)
PHONO =|2.5mv 50 kilohms | 74 dB .
72 dB* (A, 2.5 mV)
300 mV 50 kilohms [95 dB
80 dB* (A, 200 mV)
VIDEO 1, 2 | 200 mV
TAPE
Outputs
REC OUT, VIDEO 1 Voltage 200 mV
(AUDIO)
OUT
Impedance
10
kilohms
HEADPHONES
Accepts
low
and
high
impedance
headphones
*'78 IHF
Tone controls
BASS: +10 dB at 100 Hz
TREBLE: +8 cB at 10 kHz
+7 dB at 70 Hz
—Continued on next page—
FM STEREO/FM-AM RECEIVER
SON Y.

Sony STR-D511 Specifications

General

Brand	Sony
Model	STR-D511
Category	Stereo Receiver
Language	English