To Next PageTo Next Page
Need help?Do you have a question about the Sony STR-DE997 and is the answer not in the manual?
General| Power Output | 100 W per channel (8 ohms, 20 Hz - 20 kHz, 0.09% THD) |
|---|---|
| Channels | 7.1 |
| Frequency Response | 10 Hz - 100 kHz |
| Total Harmonic Distortion (THD) | 0.09% |
| Digital inputs | 3 x optical, 1 x coaxial |
| Video Connections | Composite, S-Video |
| Tuning range | FM: 87.5 - 108.0 MHz, AM: 530 - 1, 710 kHz |
| Speaker load impedance | 8 ohms |
Illustrates connecting components via digital audio output jacks.
Illustrates connecting components via video, S-video, and component video jacks.
Explains connecting multi channel output jacks from players or decoders.
Instructions for connecting the supplied AM loop and FM wire antennas.
Instructions for connecting the AC power cord to a wall outlet.
Procedure to initialize the receiver and reset settings to factory defaults.
Details on setting speaker size, distance, and type in the SET UP menu.
Instructions on using the test tone to adjust speaker levels and balance.
Guide to adjusting individual speaker levels and balance using the receiver's LEVEL menu.
How to select the audio input source for playback.
How to bypass processing for high-quality analog audio playback.
Allows selection of decoding modes for audio sound.
Receiver automatically detects and decodes input audio signals.
How to select movie sound fields like CINEMA STUDIO EX modes.
How to select music-oriented sound fields like HALL, JAZZ CLUB.
Details on selecting OFF, AUTO, or ON for surround back decoding based on input stream.
How to assign a digital audio input to a different input for convenience.
How to assign a component video input to another visual input.
How to set the audio input mode (AUTO 2CH, COAX FIXED, OPT FIXED, ANALOG FIXED).
Guide to adjusting individual speaker levels and balance.
Adjustments for bass, treble, and equalizer on/off.
Setting the surround back decoding mode (OFF, AUTO, ON).
Instructions for recording audio to cassette tape or MiniDisc.
Identifies buttons and details their operations across pages 47-49.
How to program the remote to control non-Sony or compatible Sony components.
How to teach the remote to control components by learning their commands.
How to link multiple IR codes into a single command sequence.
General safety advice regarding objects, liquids, power, heat, placement, and cleaning.
Troubleshooting steps for no sound or low-level sound from components or speakers.
