Setting the volume control for Zone 2 (Zone2 Line Out) [212]
System Settings
Selecting the language (Language) (for USA, Canadian, European and Australian
models only) [213]
Tuning on/off the display for the volume level or sound field (Auto Display) [214]
Setting standby mode (Auto Standby) [215]
Switching the brightness of the display panel (Dimmer) [216]
Using the sleep timer (Sleep) [217]
Receiving information on newer software (Software Update Notification) [218]
Deleting personal data (Initialize Personal Information) [219]
Assigning a name to the receiver (Device Name) [220]
Checking the software version and MAC address of the receiver (System
Information) [221]
Checking software license information (Software License Information) [222]
Updating the software automatically (Auto Update Settings) [223]
Updating the software (Software Update) [224]
Using the menu on the display panel
Operating the receiver with the menu on the display panel [225]
Viewing information on the display panel [226]
Reverting to the factory default settings [227]
Troubleshooting
Error messages
PROTECTOR [228]
[Overload occurred.] appears on the TV screen. [229]
List of messages after Auto Calibration measurements [230]
General
The receiver is turned off automatically. [231]
Cannot find an available input when connecting several digital devices. [232]
The receiver does not turn on even when the TV is turned on. [233]
The receiver turns off when the TV is turned off. [234]
The receiver does not turn off even when the TV is turned off. [235]
Image
No image appears on the TV screen. [236]
No 3D content appears on the TV screen. [237]
To Next Page
