This function does not work in the following cases:
Headphones are connected.
[Auto Calibration] has not been performed.
[Bluetooth Mode] is set to [Transmitter].
[DSD Native] is set to [On] and DSD signals are being played back.
[Pure Direct] is set to [On].
The receiver may play signals at a lower sampling frequency than the actual sampling frequency of
the input signals, depending on the audio format.
[157] Adjusting Settings Speaker Settings
Outputting a test tone from each speaker (Test Tone)
You can output a test tone from each speaker in sequence.
Note
This function is not available when [Bluetooth Mode] is set to [Transmitter].
Hint
To adjust the level of all speakers at the same time, press +/–. You can also use MASTER
VOLUME on the receiver.
The adjusted value is shown on the TV screen during adjustment.
To output a test tone from adjacent speakers
See “Adjusting the balance between adjacent speakers by outputting a test tone (Phase
Noise).”
To output the source sound from adjacent speakers
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Test Tone].
2
Select the setting you want.
Off
Auto: The test tone is output from each speaker in sequence.
Front L, Center, Front R, Surround R, Surround L, Sur Back L, Sur Back (*), Sur
Back R, Height L, Height R, Subwoofer: You can select which speakers will output
the test tone.
3
[Sur Back] appears when only one surround back speaker is connected.
*
Adjust the speaker level.
4
To Next Page
