Sony TC-FX211 - Model Identification and Safety Checks; Model Identification Label; Safety Leakage Test Procedures

Chapter 2 Playback
Playing Back
Follow the procedure below to play back a cassette.
1 Turn on the amplifier and select the tape
function.
L
2 Insert a cassette.
3 Set DOLBY NR to the same position that was
used when the cassette was recorded.
Dolby NR system /-OAOFF (left) | B/C (right)
B type o
C type a |
| OFF Either position |
4 Press PLAY to start playback.
To stop playback, press the Hi & button.
To stop playback momentarily, press the RE button.
To restart playback, press the HE button.
To fast forward the tape, press the »P button.
To rewind the tape, press the <4 button.
To shut off the unit after winding the tape, press the B&
button.
For headphone listening
Connect the headphone plug to the HEADPHONES jack.
Is it necessary to set the tape type being used?
No. The deck has an automatic tape type detection system.
Of the four major types of tapes, your unit can use TYPE |
(normal), TYPE tl (CrOz) and IV (metal). The tape detection
system automatically adjusts the equalization and bias
current to the optimum level for the type of cassette
detected.
What is the Dolby NR system?
The Dolby NR (noise reduction) system reduces tape hiss
noise in low-level, high-frequency signals by boosting the
signals during recording and lowering them during playback.
Before turning off the power
Be sure to release the B™ button by pressing the @ & button.
Otherwise, the tape may become tangled when power is
turned on again.
After winding the tape using the <4 or BP button
Be sure to press the i & button to release the fast winding
button.