Sony TC-WR465 - Advanced Recording Operations; Dubbing a Tape

Advanced Recording Operations
Dubbing a Tape
You can copy a tape in deck A to a tape in deck B at
normal or high speed.
DIRECTION PAUSE IE
a HIGH NORMAL
1 Insert the recorded cassette into deck A and a blank
cassette into deck B.
Make sure the record-protect tabs on the cassette in
deck B have not been removed.
2 Select the side(s) to be recorded on.
Set DIRECTION to To record on
—
One side —
Both sides C5.
Recording on the reverse side on
deck B starts independently of
playback on deck A.
RELAY.
Recording on the reverse side on
deck B starts simultaneously with
playback of the reverse side on
deck A.
3 Press HIGH or NORMAL to select the dubbing
speed.
“HIGH” or “NORM” appears in the display.
The tape deck changes to dubbing standby.
4 Select the side from which to start dubbing.
To record from Press
The front side co
The reverse side <J
5 Press PAUSE IM to start dubbing.
To stop dubbing
During Press
Normal-speed dubbing M@ ondeck B
High-speed dubbing @ on either deck
cer During high-speed dubbing
Only @ is operative.
cer You don't have to adjust the recording level or select
the Dolby NR system during dubbing
Dubbing is automatically performed with the same
recording level and Dolby NR system as the original in
deck A. If, however, you want to monitor the sound
during normal-speed dubbing, set DOLBY NR .v mz#*5
the tape in deck A (see page 5).
Note
If a TV set is placed near the tape deck, noise may occur during
high-speed dubbing. In that case, turn the television set off or
move it away from the tape deck.
Dubbing only specific portions
You can do this only during the normal-speed
dubbing.
1 Press Ml on deck A at the portion you want to skip.
Deck B changes to recording pause.
2 Locate the point you want to resume recording on
deck A, then stop the tape.
3 Press PAUSE If to resume dubbing.