Sony TC-WR465 - Inserting a Blank Space During Recording (Record Muting); Additional Information; Precautions

Inserting a Blank Space During
Recording (Record Muting)
You can insert a blank space of 4 seconds between each
track or erase unwanted portions on a tape.
PAUSE If
RECMUTEQ [>
1 Start recording.
2 Press REC MUTE O where you want to insert a
blank space.
“REC” flashes in the display and a blank is recorded
on the tape.
After 4 seconds, “Il” lights up and the tape deck
changes to recording pause.
3 Press PAUSE #1 or [> to resume recording.
xe) If you want to insert a blank space longer than 4
seconds
Hold down REC MUTE O as long as you want. After 4
seconds, “REC” flashes faster.
When you release REC MUTE O, “IN” lights up and the
tape deck changes to recording pause.
Press PAUSE Wf or [> to resume recording.
Additional information
aS a eee)
Precautions
On safety
© Do not disassemble the cabinet — this may result in an
electrical shock. Refer servicing to qualified personnel only.
¢ Should any solid object or liquid fall into the cabinet, unplug
the tape deck and have it hecked by qualified personnel
before operating it any further.
On power sources
* Betore operating the tape deck, check that the operating
voltage of the tape deck is identical with your local power
supply. The operating voltage is indicated on the nameplate
at the rear of the tape deck.
¢ The unit is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet, even if
the unit itself has been turned off.
* If you are not going to use the tape deck for a long time, be
sure to disconnect the tape deck from the wall outlet. To
disconnect the AC power cord, grasp the plug itself; never
pull the cord.
* AC power cord must be changed only at the qualified
service shop.
On operation
Because of a safety mechanism, the function buttons will not
operate if the cassette holder is not completely closed, if there is
no cassette in the cassette holder, or if a cassette has been
incorrectly inserted into the cassette holder.
On placement
¢ Place the tape deck in a location with adequate ventilation to
prevent heat build-up in the tape deck.
* Do not place the tape deck:
— ona soft surface such as a rug that might block the
ventilation holes on the bottom.
— ina location near heat sources.
— ina place subject to direct sunlight.
— in an inclined position.
— ina place subject to excessive dust or mechanical shock.
On cleaning the tape deck
Clean the cabinet, panel and controls with a soft cloth slightly
moistened with a mild detergent solution. Do not use any type
of abrasive pad, scouring powder or solvent such as alcohol or
benzine.
For the customers in the United States
For detailed safety precautions, see the leaflet “IMPORTANT
SAFEGUARDS”.
If you have any questions or problems concerning your
tape deck, please consult your nearest Sony dealer.