Sony TRINITRON KV1380R - Page 7

Preparation
Make sure the following are properly set on the TV.
¢ On-screen “EXT-A” indication should be off.
If not, press the EXT-AUDIO button.
¢ On-screen “VIDEO” indication and the VIDEO indicator
should be off.
If not, press the TV/VIDEO button so that they disappear.
« AUTO STEREO button
Set to ON.
¢ CABLE ON/OFF selector
For cable TV channels, set to ON.
For VHF and UHF channels, set to OFF.
1 Press POWER to turn on the TV.
The channel number will be displayed on the screen for
several seconds.
2 Select channels in one of the following two ways.
¢ Press the numeral(s) of the channel and then press
ENTER.
Ex. To select channel 6, press 6 and then ENTER.
To select channel 125, press 1, 2,5 and then ENTER.
If you have pressed the wrong numeral, wait for a few
seconds until the channel number display has
disappeared. Then press again.
e Press CH + for higher-numbered channels and — for
lower-numbered channels. The channels will appear in
numerical sequence.
The channel number display will disappear after several
seconds.
To keep the display on the screen, press DISPLAY.
3 Adjust the volume and picture to your preference.
Press VOL + to increase volume, — to decrease it.
Press PICTURE + to increase picture contrast, — to
decrease it.
To switch quickly between 2 channels, press JUMP.
Each time JUMP is pressed, the channel which appeared on
the screen directly before is recalled. This button enables you
to keep track of two programs alternately.
To mute the sound, press MUTING. The “MUTING” indication
will appear on the screen. To restore the sound, press
MUTING again or VOL +/-.
To tum off the set, press POWER again.
To have the TV tum off automatically after 1 hour, press
SLEEP. The “SLEEP” indication will appear on the screen for
a few seconds and the SLEEP indicator on the TV will remain
lit until the TV is turned off. To cancel the SLEEP timer, press
SLEEP again so that the SLEEP indicator goes out, or turn off
the TV.
"LISTENING
TO
MULTICHANNEL
TV:SOUND
(wit
BROADCASTS
>
Ss
To receive a stereo program
Normally set the AUTO STEREO button to ON. in this position
the STEREO indicator on the TV will light whenever a stereo
broadcast is received.
To listen to the stereo sound, select the MAIN mode with the
MTS button so that the “MAIN” indication is displayed. The
stereo sound will be heard from the built-in left and right
speakers.
Every push on the MTS button changes the indication as
follows:
MAIN ———-> SAP ——--> BOTH
Select the appropriate mode according to various possible
incoming broadcast signals.
When there is a SAP (Second Audio Program) broadcast
Select the SAP mode so that the “SAP” indication is
displayed, and only the SAP sound will be heard from both
speakers.
To listen to both MAIN and SAP broadcasts
Select the BOTH mode so that the “BOTH” indication is
displayed. The MAIN and SAP sounds will come out from the
left and right speakers respectively.
The MAIN sound becomes monaural(mixed) even when there
is a stereo broadcast, because the sound comes only from
the left speaker.
Notes
¢ There may be cases of stereo broadcasts where
excessive “noise” will be heard due to a weak incoming
signal. By setting the AUTO STEREO button to OFF and
returning to monaural mode, the noise should be
eliminated.
¢ When the SAP or BOTH mode is selected and there is no
SAP broadcast, no sound is heard from the speakers (in
SAP mode) or the sound is heard only from the left
speaker (in BOTH mode).
e The SAP broadcast will always be transmitted with the
MAIN broadcast.