Sony Trinitron KV-SA28

Questions and Answers

S
Steven WilliamsAug 6, 2025
What to do if my Sony TV has no picture and no sound?
- M
  Misty MartinezAug 6, 2025
  First, check the power cord, antenna, and VCR connections to ensure they are properly connected. If the connections are correct, make sure the TV is turned on by pressing the power button. If it doesn't work, turn off the TV for about five seconds using the main power button on the TV, and then turn it back on.
P
Patrick HartAug 11, 2025
Why does my Sony TV have a good picture but no sound?
- S
  Steve WheelerAug 11, 2025
  First, ensure that the volume level is not set too low by pressing the volume up button. Also, check if the sound is muted and, if so, press the mute button to cancel it.
N
Nicholas CastilloAug 16, 2025
How to solve good picture but noisy sound on Sony TV?
- N
  Nicholas WilsonAug 16, 2025
  Display the “Channel Setup” menu and select the appropriate “TV System” from “Manual Program.”
U
ujohnstonAug 21, 2025
How to fix a Sony TV with a snowy picture and noisy sound?
- D
  dvaldezAug 21, 2025
  Check the antenna cable and its connections on the TV, VCR, and at the wall to ensure they are secure and undamaged. If the connections are fine, check the antenna setup. If the issue persists, display the “Channel Setup” menu and set the “Signal Booster” to “Auto” from “Manual Program”. You might also want to try using an external booster.
I
ibrownAug 26, 2025
What to do if my Sony Trinitron KV-SA28 has a distorted picture and noisy sound?
- N
  Norma RobinsonAug 27, 2025
  If you are using an external booster, try turning it off or disconnecting it. You can also display the “Channel Setup” menu and set the “Signal Booster” to “Off” from “Manual Program.”
Y
yatkinsAug 31, 2025
How to fix no color on my Sony TV?
- K
  Kelly AlexanderSep 1, 2025
  First, display the “Picture” menu, select “Personal” of “Mode”, and adjust the “Color” level in “Picture Adjustment.” If the issue persists, display the “Setup” menu and check the “Color System” setting, ensuring it is set to “Auto”.