Sony TRINITRON PVM-1443MD - Page 5

[11] UNDER SCAN button
Depress for underscanning. The display size is reduced
by approximately 3% so that four corners of the raster
are visible.
12} BLUE ONLY button
Depress to turn off the red and green signals. A blue
signal is displayed as an apparent monochrome picture
on the screen. This facilitates “chroma” and “phase*”’
control adjustments and observation of VTR noise.
* “Phase” control adjustment is effective only for the NTSC signals.
_ [13] H-V DELAY button
Depress to observe the horizontal and vertical sync
signals at the same time.
The horizontal sync signal is displayed in the left quarter
of the screen; the vertical signal is displayed near the
center of the screen.
ANALOGIDIGITAL (EXT SYNC) button.
This button functions as ANALOG/DIGITAL selector and
EXT SYNC selector. :
As ANALOGIDIGITAL selector
Depress to monitor a signal fed through the ANALOG
RGB connectors.
Release to monitor a signal fed through the DIGITAL
RGB connector.
For EXT SYNC selector
Depress to operate the monitor on an external sync
signal fed through the EXT SYNC connector on the rear
panel (EXT).
Release to operate the monitor on the sync signal from
the displayed composite video signal (INT).
[13] H-V DELAY button
roe ANALOG/DIGITAL (EXT SYNC)
button
[15| CONTRAST buttons
——{16] VOL (volume) buttons
POWER switch and indicator
S]
[15] CONTRAST buttons
Press + to make the contrast, color intensity and
brightness stronger or — to make them weaker.
VOL (volume) buttons
Press + for more volume or — for less.
POWER switch and indicator
Depress to turn the monitor on.
The indicator will light up in green.
Press the switch again to turn the monitor off.
The picture adjustment buttons operate in the following
input mode (indicated as “Yes’’).
Yes
Yes
Yes
Yes
_ (NTSC only)
Yes
Yes