>VM-1450QM/1454QM
10. Adjust I 16: 9 BLK START (SO)!and j 16: 9 BLK END (SO)!
in the same manner as in 7 and 8 above so that the vertical
direction frame count is 11.2 for the light emitting section of
the screen and at the same time the top and bottom block
amounts are the same.
4-2. V-BLK Adjustment (PVM-1450QM only)
I. Put the unit into service mode.
2. Input an adjustment value of ill fod 60-V BLK I.
3. Input an adjustment value of 66 for j s5-V BLK j.
5. VERTICAL DEFLECTION SECTION Adjustment
* PVM-1450QM has no 16: 9 mode.
Normal V. Size Standards
525
4:3 11. 75 ± 0.2 frames
114.
154 ± 2mm
16: 9
I 20·
217 ± 3mm
1. Input a 525 monoscope signal.
2. Set:
CONT······ 80%
BRT·········S0%
3. Put the unit into service mode.
625
11.2 ± 0.2 frames
4. Adjust the size to 12 frames with I NOR 60 V SIZE I.
Adjust the vertical linearity with~.
Adjust the vertical centering with I 60 V CENT I.
Note: The V.CENT adjustment must be re-evaluated after
the Y.LIN adjustment.
Adjust the size to the standard value with
INOR 60 V SIZEI,
5. Put the unit into 16 : 9 mode.
6. Adjust in the same manner with I 16: 9 NOR V SIZE (60) I.
7. Put the unit into normal scan mode.
8. Input a 625 monoscope signal.
9. Roughly adjust I NOR SOY SIZEjso that the size is 11 frames.
Adjust the vertical centering with I 50 V CENT I.
Note: The V.CENT adjustment must be re-evaluated after
the V.LIN adjustment.
Adjust the size to the standard value with
INOR 50 V SIZEj.
10. Put the unit into 16 : 9 mode.
I 1. Adjust in the same manner with I 16 : 9 NOR V SIZE (50) I.
6. HORIZONTAL DEFLECTION SECTION ADJUSTMENT
NORMAL SCAN Adjustment
* PVM-1450QM has no 625 mode.
1. Input a 525 monoscope signal.
2. Set:
CONT······ 80%
BRT·········50%
3. Put the unit into service mode.
4. Roughly adjust !NOR H SIZEI so that the size is 15.75
frames.
5. Adjust the horizontal deflection section with
!NOR PIN AMPI, !NOR PIN PHASEI, !NOR U/L PINI,
ISEXYI, jv BOW! and IV ANGLE!.
(While adjusting the pincushion distortion and bow distortion
with V-ANGL and BOW, adjust so that the horizontal and
vertical of the screen are straight lines.)
6. Put the unit into 16 : 9 mode.
7. Adjust with! 16: 9 NOR PIN AMP!,
j 16 : 9 NOR PIN PHASE I, and I 16 : 9 NOR U/L PIN! in the
same manner as in Item 5.
Normal H.Size Standards
525 625
4:3 15.75 ± 0.2 frames 15.0 ± 0.2 frames
16: 9 15.75 ± 0.2 frames 15.0 ± 0.2 frames
V-ANGL
rzzzJ ~ITOJ ¢: I\\\I
BOW
!ill] => [OJ <= [DJ
PIN-AMP
[I] => [OJ ¢: [I]
PIN-PHASE
[IIT] => [OJ ¢ [ill]
U/L-PIN
[[]] => [I[] <;= [[J]
SEXY
a
~
om ¢: a
Fig. 4
- 34 -
To Next Page