What causes weak sound on my Sony Tuner?
If the sound from your Sony Tuner is weak, the supplied cables and connected device might not be connected properly. Refer to the operating instructions of the connected device, and perform proper connections.
What to do if there is sound interruption or noise on my Sony Radio?
If you are experiencing sound interruption or noise with your Sony Radio, it could be due to several reasons. One potential cause is having two or more transmitters set to the same channel. Two or more transmitters cannot be used on the same channel. Refer to the frequency list stored on the supplied CD-ROM, and reconfigure the channel on each transmitter. Another cause might be that the transmitters are not set to channels within the same channel group. Set each transmitter to a different channel within the same channel group. Also, using adjacent channels can cause interference; use channels separated by at least two channels (250 kHz). Finally, jamming radio waves can cause interference. Set the channel on the receiver to a channel for which the RF indicator does not light, or use the C...
What to do if there is sound interruption or noise on my Sony Tuner?
Sound interruption or noise can occur in your Sony Tuner if two or more transmitters are set to the same channel. Two or more transmitters cannot be used on the same channel. Refer to the frequency list stored on the supplied CD-ROM, and reconfigure the channel on each transmitter. Also, the transmitters may not be set to the channels within the same channel group. The channel plan is set so that no signal interference occurs when two or more transmitters are used simultaneously, so set each transmitter to a different channel within the same channel group. Adjacent channels being used can also cause this problem, so use the channels separated by at least two channels (250 kHz). Finally, jamming radio waves may be received. In this case, set the channel on the receiver to a channel for whic...
Procedure for selecting the desired group and channel for reception.
Scans for unused channels within a selected group to find available frequencies.
Scans for active channels within a group, useful for multi-receiver setups.
Configures the compander mode for compatibility with different transmitters.
Allows sending frequency and compander settings to a transmitter.
Automatically sets channels and configures transmitters using infrared.
Manually configures group/channel and settings via infrared sync.
Procedure for setting the headphone monitor audio level.
Adjusts the monitor audio level for headphones within a specified range.
Specifies precedence between batteries and external power sources.
Covers GP/CH, BATTERY, CONTRAST, and VERSION settings.
Details CLR SCAN, SYNC, COMPANDER, ACT SCAN, and ASSIGN functions.
Covers AUTO SET for automatic channel configuration and RESET for factory defaults.
Settings for MIC SELECT, INPUT LEVEL, LCF, PHASE, and ASSIGN for external mics.
Explains common error messages like EEP, PLL, and NO TONE, and their solutions.
General| Quantity | 1 |
|---|---|
| Antenna type | Removable |
| Display type | LCD |
| Ethernet LAN | No |
| Mounting type | Camera mount |
| Product color | Black |
| Built-in display | Yes |
| Antennas quantity | 2 |
| Channels quantity | 33 channels |
| Operating frequency type | Ultra High Frequency (UHF) |
| Radio Frequency (RF) range | 566.025 - 630 MHz |
| Operating temperature (T-T) | 0 - 50 °C |
| Signal-to-Noise Ratio (SNR) | 96 dB |
| Microphone frequency response | 23 - 18000 Hz |
| Total Harmonic Distortion (THD) | 0.9 % |
| Battery type | AA |
| Input voltage | 5 V |
| Power supply type | Battery |
| Battery life (max) | 5 h |
Weight and Dimensions| Depth | 28.4 mm |
|---|---|
| Width | 63 mm |
| Height | 82 mm |
| Weight | 210 g |
To Next Page