115
7. Connecting External Devices
Connecting a Remote Control Unit
When an RM-B170 Remote Control Unit,
RCP-1001/1501/3100/3501 Remote Control
Panel, or other control unit is connected, some
functions can be controlled from that unit.
Connecting a Remote Control Unit
Connect the camera connector of the control
unit to the REMOTE connector (8-pin) of the
unit using a remote control cable.
When you turn on the unit after making the
connection, the unit enters remote control
mode, enabling menu operations and
shooting operations.
[Notes]
• Do not connect or disconnect the remote control unit
when the unit is on.
• A remote control cable is not supplied with the RCP-
1001/1501/3100/3501 Remote Control Panel.
Releasing Remote Control Mode
Turn off the unit, and disconnect the remote
control unit.
Setting the Paint Function
Technical > Special Configuration > RM/RCP
Paint Control (page 91) must be set to On in
the full menu to enable the paint function.
To Next Page
Loading...
