What to do if my Sony VPL-CS6 Projector power is not turned on?
If your Sony Projector isn't powering on, it could be due to a few reasons. If the power was recently turned off and on quickly, wait about 90 seconds before trying again. Also, check that the lamp cover and the air filter cover are securely closed. Ensure both are properly attached.
Why does 'Please check Input-A Signal Sel.' appear on my Sony VPL-CS6?
The message 'Please check Input-A Signal Sel.' on your Sony Projector indicates an issue with the Input-A Signal Sel. setting. This can happen if you've input an RGB signal from the computer while the setting is configured for 'Component.' To resolve this, set 'Input-A Signal Sel.' correctly.
Why is there no sound on my Sony VPL-CS6 Projector?
If you're experiencing a 'no sound' issue with your Sony Projector, verify that the cables are correctly connected. If using an audio cable, ensure it's a no-resistance stereo audio cable. Also, check and adjust the sound settings on the projector.
Why does my Sony Projector say 'Frequency is out of range!'?
The 'Frequency is out of range!' message on your Sony Projector indicates that the input signal's frequency is outside the projector's acceptable range. Try inputting a signal within the supported frequency range. Additionally, the resolution setting of the computer's output signal might be too high; set the output to XGA (VPL-CX6/EX1) or SVGA (VPL-CS6).
Why does the picture from INPUT A connector look colored strange on my Sony VPL-CS6 Projector?
If the picture from the INPUT A connector on your Sony Projector looks strangely colored, the 'Input-A Signal Sel.' setting in the SET SETTING menu is likely incorrect. Select 'Computer,' 'Video GBR,' or 'Component' correctly according to the input signal.
What does it mean when my Sony VPL-CS6 displays 'Please replace the LAMP.'?
If your Sony Projector displays the message 'Please replace the LAMP,' it means it is time to replace the lamp.
Why does the image extend beyond the screen on my Sony VPL-CS6 Projector?
If the image extends beyond the screen on your Sony Projector, it could be because the APA key was pressed when there were black edges around the image. Try displaying the full image on the screen and then press the APA key. You can also adjust the 'Shift' setting in the INPUT SETTING menu.
What to do if the Remote Commander does not work with my Sony VPL-CS6 Projector?
If the Remote Commander isn't working with your Sony Projector, the batteries are likely dead. Replace them with new ones.
What to do if the LAMP/COVER indicator lights up on my Sony VPL-CS6?
If the LAMP/COVER indicator is lit on your Sony Projector, it means the lamp has reached the end of its life and needs replacement. It could also indicate the lamp is overheating; allow it to cool down for 90 seconds before turning the power back on.
How to fix a Sony Projector when the picture is not clear?
If the picture on your Sony Projector is unclear, it could be out of focus; try adjusting the focus. Alternatively, condensation might have formed on the lens; if so, leave the projector on for about two hours to clear it.
To Next Page
General
