31 Slot 0 bypass Transport stream is set to bypass slot 0.
This command is effective only when there is no CAM
inserted into slot 0.
32 Slot 0 pass thru Transport stream is set to pass out/in slot 0.
This command is effective only when there is no DVB
compliant CAM inserted into slot 0.
If there is no output/input device then the demux will
not receive a valid transport stream.
33 Slot 1 bypass Transport stream is set to bypass slot 1.
This command is effective only when there is no CAM
inserted into slot 1.
34 Slot 1 pass thru Transport stream is set to pass out/in slot 1.
This command is effective only when there is no DVB
compliant CAM inserted into slot 1.
If there is no output/input device then the demux will
not receive a valid transport stream.
35
36
37
38
39
Software upgrade
41 Upgrade Serial Forces a software upgrade from the serial port
STB will reset after loading & TT mode will be
cancelled
Yes
42 Upgrade Ethernet Forces a software upgrade from the Ethernet port (if
available)
STB will reset after loading & TT mode will be
cancelled
Yes No
43 Upgrade off-air Forces a software upgrade from the current service
A change of service, satellite, etc will be done as
required.
STB will reset after loading & TT mode will be
cancelled
Yes
44 Upgrade Memory
stick
Forces a software upgrade from the Memory stick (if
available)
STB will reset after loading & TT mode will be
cancelled
Yes
45
46
47
48
49 Allow downgrade On next SW update, update the software even if the
version is older than, or the same as, the current
version
Yes
Screen control
51
52
53
54
55
56
57
58
59
I/O
61 LED OFF Sets all LED’s Off
To Next Page
Loading...
