- 8 -
Service Manual
4 List of TT commands
Depending on the STB model the number of digits which are capable of being entered will vary, therefore any
leading zero have been omitted from the TT number defined in the list. Entries should be made according to
the description in section 3.
All commands ending in zero (ie. 0, 10, 20, 30, 40) etc reset the display, cancelling partially entered
commands.
All settings, except those marked “Permanent”, are reset after a power cycle.
TT Name Description Permanent Supported
0 Revert to normal Stops TT mode and returns the STB to normal active
mode.
It does not necessarily revert to the mode of
operation prior to TT mode being entered.
1 STB reset Force the box to reset
This resets the state of the box to just powered on.
STB will power on in standby mode.
2
3
4
5
6 Factory reset &
reboot
Reset all settings to defaults (shipping)
Reboot
Yes
7 Factory reset Reset all settings to defaults (shipping) Yes
8 Shipping default
& reboot
Set the box to shipping condition
Tune database is cleared
Reboot - Start-up menu will be activated
Yes
9 Shipping default Set the box to shipping condition
Tune database is cleared
Yes
SCART/AV
11 Colour bar ON Enable colour bar output on TV & VCR SCART
When colour bar is enabled the OSD cannot be seen.
12 Colour bar OFF Disable colour bar output on TV & VCR SCARTS
13 Smart link test Sends a sequence of commands to the AV link bus.
Appendix A shows the sequence sent.
No
14 Scart control off Sets pin 8 on all SCART sockets to 0V No
15 Scart control 16:9 Sets pin 8 on all SCART sockets to 16:9 level No
16 Scart control 4:3 Sets pin 8 on all SCART sockets to 4:3 level No
17
18
19
21
22
23
24
25
26
27
28
29
Common interface
To Next Page
Loading...
