Sony WRT-810A - Page 11

3 Set the POWER switch to OFF to save the selected channel
number along with the current input attenuation setting.
AF RF BATT |
TV/ATT CH :
The unit cannot transmit in channel! set mode.
Make sure that the channel selected is the same as that selecied on
the WRR-820A/840A unit used in the same System.
Depending on the noise or interference conditions, the selectable
channels may not necessarily all be usable. If necessary, you can
determine the usable channels by stepping the channel selection
through a number of channels on the tuner with the microphone/
transmitter set to OFF. Those channels on which the RF indicator of
the tuner does noi light are usable.
If there is a TV broadcasting station nearby, to avoid possible
interference with broadcasing, do not use that station’s channel. _
The unit may not operate correctly if it is turned on again immediately
after turning off the power while in channel set mode. Pause for a few
seconds or more before turning on the power again.
14