1-14. IP Video Interface (ST2110) Boards
This section describes the web menu of the firmware of the following IP video interface boards.
• XKS-C8111
• XKS-C8166
• XKS-C9111
• XKS-C9121
1-14-1. Displaying Web Menu
Equipment required
• Personal computer (PC): A PC that can be connected to the IP Video Interface board through a network and supports
the following recommended web browsers.
Recommended web browsers
- Google Chrome (64bit) 72 (Verified version) or later
Procedure
1. Check the IP address of the target device by using XVS MENU (7311.2) or LSM (AV Router > Settings > Device).
2. Run the web browser on the PC.
3. Type “https://(IP address of update target device)”on the address bar, and then press the Enter key.
4. On the displayed screen, enter ID and password.
Tip
• The following table shows the initial account (factory default).
Account Type User ID Password
Administrator admin nmidev123
Operator operator nmidev123
• At the time of the first access, changing the account information is required.
For how to change the account information at subsequent accesses, refer to “1-14-2. Changing Account”.
• The following table shows functional restrictions for the web menu due to differences in Account Type.
Function Account Type
Administrator Operator
Firmware Update 〇 —
Changing the user ID and password of all users (administrator and operator) 〇 —
Changing only the user ID and password of operator authority 〇 〇
Downloading the information file 〇 —
Uploading the installation key 〇 —
Changing SNMP settings 〇 〇
Changing NMOS settings 〇 〇
Browsing and downloading log data (access to /logview.cgi?html) 〇 〇
Rebooting boards 〇 —
XVS-9000-C/XVS-8000-C/XVS-7000-C/XVS-6000-C
1-27
To Next Page
Loading...
