o the power cable is damaged
o it does no longer work properly
► Immediately turn off the AP in the event of one of the above problems, remove the
power cable from the power socket and contact your competent customer service
as soon as possible.
► We expressly exclude any product liability and warranty claims if the AP is not
operated according to the instructions in these security notes and to the notes
attached to the AP itself!
PoE-Injector Safety Information
► Connect the PoE-Injector to PoE networks only, without routing to the outside
plant.
► AC Power Cord:
o The power cord must have regulatory agency approval for the specific
country in which it is used (for example, UL, CSA, VDE, GS, etc.).
o The power cord must be a three-conductor type (two current carrying
conductors; one ground conductor terminated on one end by an IEC
60320 appliance coupler (for connection to the PoE-Injector), and on the
other end by a plug containing a ground (earthing) contact.
o The power cord must be razed for a minimum of 250 VAC RMS operation,
with a minimum rated current capacity of 5 A (or a minimum wire gauge of
18 AWG (0.75 mm2)).
o A PoE-Injector installed in Australia requires power cords with a minimum
wire gauge of 16 AWG (1.0 mm2).
► The PoE-Injector "Data In" and "Data & Power Out" ports are shielded RJ45 data
sockets. They cannot be used as Plain Old Telephone Service (POTS) telephone
sockets. Connect RJ45 data connectors only to those sockets.
► The AC wall socket-outlet must be near the PoE-Injector and easily accessible.
You can remove AC power from the PoE-Injector by disconnecting the AC power
cord from either the wall socket-outlet or the PoE-Injector appliance coupler.
► The PoE-Injector "Data In" and "Data & Power Out" interfaces are qualified as
Safety Extra-Low Voltage (SELV) circuits according to IEC 60950-1. Connect
these interfaces only to SELV interfaces on other equipment.
Warnings
► Connect the PoE-Injector only to the IP device with which it was bought. Using the
PoE-Injector with other IP devices can cause damage to the IP device.
To Next Page
Loading...
Need help?
General
