Sophos APX Series - Reboot and Reset Procedures; Reboot with Current Configuration; Reboot and Clear Configuration

4
3. Configuration
After successful connection to the wireless controller the status LED turns to solid green.
The access point is now ready to be managed.
Please refer to the documentation of your Sophos firewall/UTM or the Sophos Central
online help to start the configuration of your access point.
4. LED Status
Off
Off AP is off or reboot started
Green
Solid Normal operation
Flashing AP is booting & connecting to wireless controller
*
Red
Solid Error, no wireless controller found. AP will
reboot (if not yet claimed by a controller).
Check network connection if error persists.
If reset button pressed: AP preparing
configuration reset
Flashing slowly Configuration reset in progress
*
Flashing fast Firmware update in progress
*
Note: Do not disconnect from power
* Your AP should recover from this state after a maximum of 5 minutes.
Quick Start Guide APX Series Access Points