Sophos APX Series Quick Start Guide

5
5. Access Point Reboot & Reset
Reboot with current image and configuration
1. Press reset button
2. Release reset button
3. AP reboots (LED will go off, then will turn to solid green)
Reboot with current image and clear configuration
1. Press and hold reset button
2. AP reboots (LED will go off and then switch to green briefly)
3. LED will turn solid red for 5 sec. You can still cancel the configuration clearance
process by releasing the reset button before the LED starts blinking
4. LED will blink red (configuration will be cleared)
5. Release reset button
6. AP reboots with factory default settings
Reset
Button
Status
LED
Released
Pressed
Solid Solid Blinking
Reboot Reboot clear config
5 Sec
Off
6. Support and Documentation
For more information and technical support, please visit
www.sophos.com/en-us/support or contact your local Sophos reseller.
Quick Start Guide APX Series Access Points

Sophos APX Series Specifications

General

Wi-Fi Standards	802.11a/b/g/n/ac
Frequency Bands	2.4 GHz, 5 GHz
MIMO	2x2
Ethernet Ports	1 or more Gigabit Ethernet ports
Power over Ethernet (PoE)	802.3at PoE+
Security	WPA3, WPA2, WPA, WEP, 802.1X, AES, TKIP
Management	Sophos Central
Mounting	Ceiling, wall
Operating Temperature	0°C to 40°C (32°F to 104°F)
Model	APX 320, APX 320X, APX 530, APX 740, APX 940, APX 530X