4
3. Power Up the Device
Connect the power adapter(s) and turn on the device
Connect the provided power adapter to the power connector on the back of the
device.
Turn the device on. The power switch is on the back of the device and is placed next
to the power connection.
During boot up the Status LED on the front will blink green. Once the device has
booted completely the Status LED will turn to solid green.
4. Connect your Administration PC
Administration PC connection properties:
Use the settings below to configure your (PC/Laptop) network interface:
Ì IP address: 172.16.16.2
Ì Netmask: Enter 255.255.255.0
Ì Default Gateway: Enter the IP address of the device’s
internal network card (Port 1/LAN): 172.16.16.16
Ì DNS Server: Enable this option and enter the IP address of
the internal network card (Port 1/LAN): 172.16.16.16
Connect your PC/Laptop to Port 1/LAN port of the device:
Start the browser and enter the management IP address of the device’s LAN port
that your PC is connected to: https://172.16.16.16:4444 (Port 1)
Login with the default details below:
Username: admin Password: admin
Quick Start Guide XG 86(w) Rev. 1
To Next Page
Loading...
Need help?
General
