Need help?Do you have a question about the Soundcore VR P10 and is the answer not in the manual?
General| Driver Size | 11mm |
|---|---|
| Frequency Response | 20Hz-20kHz |
| Bluetooth Version | 5.2 |
| Battery Life | 6 hours |
| Total Battery Life with Charging Case | 24 hours |
| Water Resistance | IPX4 |
| Noise Cancellation | No |
| Microphone | Yes |
| Impedance | 16Ω |
| Charging Port | USB-C |
| Latency | 30ms |
| Codec | SBC, AAC |
| Bluetooth Range | 10 meters |
| Weight (per earbud) | 5g |
| Charging Time | 2 hours |
Automatic power on/off by placing earbuds in the charging case.
Manually power on earbuds by pressing the charging case button with case open.
Charge earbuds and case fully before initial use.
Charge case via USB-C cable after placing earbuds inside.
Automatic earbud connection to VR headset/console via dongle.
Pair earbuds via Bluetooth by holding case button and selecting from device menu.
Earbuds support simultaneous connection to two devices via dongle and Bluetooth.
Tap twice (R) to play or pause music.
Tap twice (L) to skip to the next track.
Tap once (R) to increase volume.
Tap twice (L/R) to answer or end a call via Bluetooth.
Tap and hold for 2 seconds (L/R) to reject or end a call.
Tap and hold for 2 seconds (L/R) to end a call via Dongle.
Reset earbuds by holding case button for 10s if pairing issues occur.
Reset dongle by plugging into USB-C and using a sharp object for 3s.
To Next Page