Vi V4.5 Quickstart Guide.doc Page 7
DETAILED CONSOLE OPERATION OF VM
2
Setting up and using VM
2
monitoring on a Vi Series console falls into four simple
steps:
• Connect up the HiQnet network as described in the previous section and
check that the IP address configuration is correct on all devices.
• Connect up the audio connections from the AKG Receivers to the console
(either to Stagebox or local inputs as appropriate).
• Associate each AKG receiver with a console connector using the mapping
table in the Vi’s HiQnet Setup page
• The microphone monitoring information will now automatically be displayed
on any channel strip which uses an AKG-mapped physical input connector as
its patched source.
The following pages describe in more detail how to carry out the second two steps.
Note: Screenshots shown are for Vi2/4/6. Vi1 will have same controls but layout will
differ).
To Next Page
Loading...
Need help?
General
