EasyManua.ls Logo

SoundLogic XT P-921 - Troubleshooting; Low Sound Level Issues; Sound Distortion and No Sound; Care and Maintenance

SoundLogic XT P-921
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Troubleshooting
Problem Possible Cause Solution
Low sound level Source (Tablet, Mobile Phone,
Laptop, etc.) volume too low.
Battery dead
Adjust source volume.
Charge Battery.
Sound distorted Battery nearly dead Charge Battery.
No sound at all. Source (Tablet, Mobile Phone,
Laptop.) turned off.
Speaker turned off.
Volume turned down source.
Media paused on source.
Turn the source on.
Turn the speaker on.
Adjust volume source.
Play media from source.
Care and Maintenance
Clean the unit with a soft, damp cloth. Never use chemicals or hard abrasives.
Keep this unit away from wet or damp surroundings.
The crossed out wheelie bin symbol on this item indicates that this product needs
to be disposed of in an environmentally friendly way when it becomes of no
further use or has worn out. Contact your local authorities for details of where to
take the item for re-cycling.
Note: iPod and iPhone are trademarks of Apple Inc, registered in the US, and
other countries
.
FCC Instructions
- Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the product.
NOTE: This product has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This product generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
the product does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the product and receiver.
- Connect the product into an outlet on a circuit different from that to which
the receiver is connected.

Related product manuals