SOUNDMASTER DAB80 - Basic Operations; Power On;Off and Standby Modes; Mode Selection and Volume Adjustment; DAB Radio Operation

BATTERY POWER INDICATOR
While the device is playing in battery mode, press the “INFO” button repeatedly until the display show “Battery xx” (xx
= Battery level). When the battery power is low and need to re-fill, the battery icon in the right corner of the
display is flashing and the display show “Battery Low”.
ERP power management
The unit will turn off automatically after about 15 minutes in standby mode if there is no audio signal. To turn
on the unit again press the “ST/BY / MODE” button.
BASIC OPERATIONS
POWER ON / OFF
Press the ” / MODE” button to turn the unit in standby. The display show “Welcome to Digital Radio” and then the
time and date is shown. In standby, press the ” / MODE” button to turn on the unit. In on mode, press and hold the
” / MODE” button to turn the unit in standby. The time and date are shown in the display. In standby, press and
hold the ” / MODE” button to turn the unit in power saving mode. Note: In standby mode, if you don´t press any
button, the unit will automatically turn off into power saving mode after about 15 seconds.
SELECTING MODES
During playing mode, press the “ / MODE” button repeatedly to switch between the modes.
ADJUSTING VOLUME
To increase or decrease the volume, rotate the “Volume Control” knob.
DAB
1. Select the mode “DAB”.
2. If you start the radio the first time, the unit will start an automatic scan and store all receivable radio stations.
3. Press the button to select a radio station from the station list and press “ Enter” to confirm the
selection.
Automatic Search
Press and hold the “AMS” button to start the automatic scan. All found stations will be stored in the station list.
Store preset station
You can store up to 30 DAB radio stations
1. Select the desired radio station.
2. Press and hold the “MEM” button until “Preset store <X: (Empty) > (X = preset station number) is shown in the
display.
3. Select with the button the station number and press “Enter” to confirm.
Recall preset station
1. Press the “MEM” button. The display show “Preset recall <X: (Empty) > (X = preset station number) in the
display.
2. Select with the button the station number and press “ Enter” to confirm.
Information (Info)
When the radio station is playing, press the “Info | Menu” button repeatedly to cycle through the information
broadcasted by the radio as follow:
➢ DLS (Dynamic Label Segmenting)
➢ Audio Bit Rate
➢ Signal strength
➢ Mains Power/Battery
➢ PTY (Program Type)
➢ Time