➢ Channel/Frequency
➢ Date
➢ Signal Error
DAB Menu
1. Press and hold the “Info | Menu” button until the display show “DAB <Full scan>. 2. Select with the
button the following settings:
Full scan
Start an automatic scan.
Manual tune
Select the desired channel and search only the selected channel.
DRC (Dynamic range compression)
If you are listening to music with a high dynamic range in a noisy environment, you may wish to compress the
audio dynamic range. This makes quiet sounds louder, and loud sounds quieter. You can change DRC as off,
low or high.
Prune
Delete all radio stations which are not receivable anymore.
TA
When “On” is selected, the radio will receive traffic announcement on some area if the radio station will provide
this service.
System
Find the system settings.
FM
1. Select the mode “FM”.
2. Press the “AMS” button to start an automatic scan. The radio store all local radio stations.
Automatic tune
Press and hold the button to start the automatic tune. The radio stops at the NeXT receivable radio station.
Manual tune
To manual tune, use the button. And it will fine tune the frequency in a step of50kHz.
Store preset station
You can store up to 30 FM radio stations. Is the same as in DAB mode.
Recall preset station
is the same as in DAB mode.
Information (Info)
When the radio station is playing, press the “ Info | Menu” button repeatedly to cycle through the information
broadcasted by the radio as follow:
➢ Radio Text
➢ Mains Power/Battery
➢ PTY (program Type)
➢ Time
➢ Name
➢ Date
FM Menu
1. Press and hold the “Info | Menu” button until the display show “FM <Scan setting>.
2. Select with the button the following settings:
• Scan setting
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss) from weak
stations. To change the scan settings to stop only at stations with good signal strength, select “Strong station only”.
• System
To Next Page
Loading...
