SOUNDMASTER MCD400 - Page 9

MCD400 / English Instruction Manual
7
SKIP+ & SKIP-
With “SKIP+ / TUNING+” button you can jump to the next or previous track etc. If the button is
kept pressed down, the machine starts to search through the tracks.
The “SKIP- / TUNING-” button can be used as follows:
Press once = This starts the current track again from the beginning.
Press twice = This jumps back to the previous track.
STOP
The playback is stopped.
MODE
In stop mode for programming any order of tracks (see the section on “Programmed Play”).
During the playback of an audio CD:
Press once = the normal play mode.The display will show “Normal”.
Press twice = the current track is repeated continuously. The display will show “Repeat One”.
Press three times = the whole CD is played continuously. The display will show “Repeat All”.
Press four times = all tracks will be played in random order. The display will show “Random”.
Press five times = back to the normal play mode.
During playback of MP3 music (Under USB mode):
Press once = the normal play mode.The display will show “Normal”.
Press twice = the current track is repeated continuously. The display will show “Repeat One”.
Press three times = the selected folder is repeated continuously. The display will show “Repeat
Folder”.
Press four times = the whole CD is played continuously. The display will show “Repeat All”.
Press five times = all tracks will be played in random order. The display will show “Random”.
Press six times = back to the normal play mode.
PRE. /FOLDER
Use the “PRE. / FOLDER” button to choose the folder.
Programmed Play
This can be used to program any desired sequence of tracks.
1. Press the “STOP” button.
2. Press the "AMS / MODE" button. “P_01” will start to flash. P_01 means the storage space.
Use the “SKIP+ / TUNING+” & “SKIP- / TUNING-” buttons to select the desired track and
then press the "AMS / MODE" button again. The display “P_01” will be changed to “P_02”.
3. Select the next track with the “SKIP+ / TUNING+” & “SKIP- / TUNING-” buttons and press
the "AMS / MODE" button again. Repeat the procedure until all the desired tracks are
selected.
NOTE:
Once the storage capacity of the tracks to be programmed has been reached “PROGFULL”
will show in the display.
4. Press the “ENTER / PLAY / PAUSE / CLOCK” button. The playback starts. The upper-left of
the display will show “MEM”.
5. Press once the button to stop the playback while retaining the program.
6. To play the programmed back again, press the “ENTER / PLAY / PAUSE / CLOCK” button.
7. To delete the program, press the “STOP” button twice. The notification “MEM” will
disappear.