MCD400 / English Instruction Manual
8
Playing back Music in MP3 Format
With this device it is possible to play back pieces of music in MP3 format. The device also
supports all standard CD types: CD, CD-RW, CD-R.
This machine of is able to play MP3 CDs. Up to 99 track scan be compressed and stored on
these CDs. Your machine detects an MP3 CD automatically (the total number of tracks and
MP3s appears in the display). If you would like to play one of these CDs, proceed as described
under “Playing CDs/MP3”. Tracks can be programmed as described under “Playing Back
Programmed Tracks”.
AUX-IN
Via this socket you can also hear the sound of other playback devices such as MP3 players, CD
players etc. through the loudspeakers.
1. Please connect the external device with a 3.5 mm stereo jack plug to the AUX-IN socket.
2. Repeatedly press the “STANDBY / FUNCTION” button, until “Aux” is shown in the display.
3. You will hear the sound playback from the external device through the loudspeakers. You
may adjust the volume with “VOLUME- / ALARM 1” or “VOLUME+ / ALARM 2” buttons. The
CD buttons are not functional.
4. For the remaining procedure please see the operating instructions of the external sound
source.
NOTE:
Adjust the volume of the external device to a comfortable level.
HEADPHONE
To listen to music privately, use headphones with a 3.5 stereo jack plug and connect to the
headphones socket on the back of the system. The speakers will then be muted.
EQUALIZER
Different sound modes are available: FLAT, CLAS(CLASSIC), ROCK, POP, JAZZ.
To select the sound modes, proceed as follows:
1. Press and hold the “EQ / FM ST.” button. The currently set sound mode will be displayed.
2. Press the “EQ / FM ST.” button again while the sound mode is being displayed.
3. If no other button is pressed within about 2 seconds, the setting will be accepted.
The set sound mode cannot be permanently shown in the display for technical reasons.
TECHNICAL SPECIFICATION
To Next Page
Loading...
