PL525 / English Instruction Manual
3
SETTING THE CLOCK
1. Set unit in standby mode.
2. Press the “MEM/CLK-ADJ” button (16) twice, the display will start flashing. Press
“Skip/Tuning” or button (5/10) to select the appropriate area hour format(12hr/24hr)
3. Press “MEM/CLK-ADJ” button (16) again, the first second digit of “0” is flashing. Press or
button (5/10) to set the correct hour. Press ”MEM/CLK-ADJ” button (16) to store the
correct hour.
4. The third fourth digit of “00” is flashing, press the or button (5/10) to set the correct
minutes. Then press “MEM/CLK-ADJ” (16) to store the correct minute.
The pre-set time will be re-set completely if disconnecting the main power supply.
You are recommended to switch the system into standby mode for convenience
usage.
LISTENING TO RADIO
Manual tuning
1. Turn on the unit by press “ON/OFF” button (12) and turn “Function” button (4) to select
“Tuner ” mode.
2. Tune to the required station by pressing the “Skip/Tuning” or button (5/10).
3. Adjust volume knob (12) to the desired volume level.
Auto tuning
1. Turn “Function” button (4) to select “ Tuner ” mode.
2. Press and hold the “Skip/Tuning” or button (5/10) for 1-2 seconds and then release.
3. The unit will start seeking automatically and stop until a radio station is reached.
4. Repeat step 2 until the desired radio station is being reached.
5. Adjust volume knob (12) to the desired volume level.
Preset stations
You can store up to 20 radio stations in the memory.
1. Set to tuner mode.
2. Tune to the desired radio station by “ manual” or “ auto ” tuning method.
3. Press and hold “MEM/CLK-ADJ” button (16) to enable program state & “ Mem ” indicator
preset station number is flashing on LCD (7)
4. Press the “FOLDER/PRE” button (11) to select the desired station memory for storage.
5. Press “MEM/CLK-ADJ” button (16) again to confirm the setting.
6. Repeat step 2 to 5 to store other stations.
7. To return normal tuner mode, leave keys free.
Press the “FOLDER/PRE” button (11) once by once to recall the preset memory.
The pre-set memories will be cancelled completely if disconnecting the main power
supply. You are recommended to switch the system into standby mode for
convenience usage.
There are 10 seconds for program state, after 10 sec. This state would resume to normal
tuner mode automatically.
You can overwrite a present station by storing another frequency in its place.
To Next Page
Loading...
