Remark
- The system can detect and read the file under MP3 format only though the USB port.
- If connect the system to MP3 player via the USB socket, due to variances in MP3 encoding format, some MP3
player may not be able to play via the USB socket. This is not a malfunction of the system.
- USB port does not support connection with USB extension cable and is not designed for communication with
computer directly
MP3 track format requirement:-
- MP3 bit rate : 32 kbps~256 kbps.
- The performance of playing MP3 file is various from the quality of recording disc and the method of recording.
Play mode
Press the play mode button (44) during playback to select repeat and random function, a single track, single folder or all the
tracks can be played in difference mode as follow:-
(1) repeat 1 (2) repeat all track (3) repeat folder (4) random (5) off mode
Indicator
Play mode on LCD display
Repeat 1 track
Repeat all
Repeat folder FOLDER
Random RAN
Off mode --------------
Repeat play
You can listen the desired tracks or folder repeatedly by this function.
Random play
You can listen all the tracks in a random order by this function
USB programming
Up to 30 tacks can be programmed for MP3 play in any order. Before use, be sure to press the “ USB stop “ button (44)
1. Set in USB mode & stop the playback.
2. Press the “mem/clk-adj” button (44), “ MEM “ will appear on LCD display. Moreover, it will indicate program no. P- 01 .
3. Select a desired track by pressing skip up or down buttons (16/44).
4. Press the”MEM/CLK-ADJ” button (44) to store the track into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press “ ” button (44) to play the disc in assigned order.
7. Press “ stop ” button (44) to terminate program play.
Press “ stop “ button (44) at USB stop mode to cancel all programmed memory.
Press the “ folder / pre-up “ button (44) to select the 1
st
track of next folder directly and hence to speed up the song
selection.
The programming model will automatically stop if no button is being pressed in a period of about 10 seconds after
pressing the “ mem/clk-adj “ button (44).
Listing to tape
General operation
Select the function button to select Tape mode. The LCD display (3) will show “ TAPE ”
Cassette playback : The system will start the playback automatically after inserting
of cassette tape
Stop and ejection : Press the “ Tape forward / Eject “ button completely inwards
and the cassette tape will be ejected though the cassette door cover. The “ Tape forward /
Eject “ button will keeping at lowest height position.
Fast forward : Press the “ Tape forward / Eject “ button half inwards during
Playback mode, the tape winding forward direction. The “ Tape forward / Eject “ button will
keeping at middle height position.
Slightly press the “ Tape forward / Eject “ button again to resume normal playback. The “ Tape
forward / Eject “ button will resume to the highest position.
Remark
- Make sure the direction is correct when inserting the tape into the system.
- There is some searching noise can be heard and the system cannot perform normal playback function during fast
forward mode.
To Next Page
Loading...
