What to do if the Protection LED comes on in my Soundstream L1.600D?
The protection LED might come on due to short circuits on speaker leads. Ensure the speaker load doesn't exceed the minimum. If the LED persists after removing the speaker lead and resetting the amplifier, the amplifier may be faulty and require servicing.
How to troubleshoot a Soundstream L1.600D that will not power up?
If your Soundstream Amplifier isn't powering up, start by checking for a solid ground connection and ensuring battery power is reaching the (+) terminal. Next, inspect all fuses and replace any that are blown. Finally, verify that the Protection LED is not lit.
Why does my Soundstream L1.600D Amplifier produce distorted sound?
Distorted sound from your Soundstream Amplifier can often be resolved by ensuring the input level control matches the head unit's signal level, keeping the input level as low as possible, and verifying that all crossover frequencies are correctly set. Also, check speaker leads for short circuits.
What to do if my Soundstream L1.600D has no output?
If you're experiencing no output from your Soundstream Amplifier, first, check that the RCA audio cables are correctly plugged into the proper inputs. Next, inspect all speaker wiring. Finally, verify the head unit output and the amplifier level setting.
Why is my Soundstream L1.600D getting very hot?
If your Soundstream Amplifier is getting very hot, ensure the minimum load impedance for your specific amplifier model is correct and that there is adequate air circulation around the amplifier. In some cases, adding an external cooling fan may be necessary.
How to fix low output on a Soundstream L1.600D?
To address low output from your Soundstream Amplifier, try resetting the level control and checking the crossover control settings.
How to reduce hiss in speakers connected to a Soundstream L1.600D?
To reduce high hiss in the speakers connected to your Soundstream Amplifier, check the RCA cable to ensure it is not shorted to power ground at the amplifier side. Also, inspect the amplifier grounding.
General| Channels | 1 |
|---|---|
| THD at RMS output | <0.1% |
| Signal to Noise Ratio | >90dB |
| Damping Factor | >100 |
| Input Sensitivity | 200mV - 6V |
| Fuse Rating | 40A |
| RMS Power at 2 Ohms | 600W |
| Frequency Response | 10Hz |
To Next Page