Need help?Do you have a question about the Soundstream ST4.1000DB and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| RMS Power @ 4 Ohms | 100W x 4 |
| RMS Power @ 2 Ohms | 125W x 4 |
| RMS Power @ 4 Ohms Bridged | 250W x 2 |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| Frequency Response | 10Hz - 40kHz |
| THD @ Rated Power | <0.05% |
| S/N Ratio | >90dB |
| Damping Factor | >150 |
| Input Sensitivity | 200mV - 6V |
| Bass Boost | 0 - 12dB |
| Power Output (RMS) | 1000W |
| Crossover Type | LP/HP/Full |
Expresses gratitude and congratulates the user on their purchase of the amplifier.
Describes the high-quality MOSFET amplifiers capable of full-range or subwoofer operation.
Warns about high-volume sound levels causing hearing loss and impairing driving safety.
Lists necessary tools for basic amplifier installation.
Provides critical safety and procedural steps before and during installation.
Explains Bluetooth as a wireless technology standard for short-distance connections.
Advises on selecting proper locations for amplifier mounting, considering airflow and protection.
Lists critical warnings related to amplifier mounting, heat dissipation, and wire protection.
Emphasizes disconnecting the battery before wiring and protecting cables.
Shows speaker output wiring for the 4-channel mode.
Solutions for amplifier power not turning on or no output with green LED.
Addresses protection mode, overheating, shutdown, and low volume problems.
Troubleshoots Bluetooth connection and external noise interference.
Provides solutions for poor bass response and speaker polarity issues.
To Next Page