~
HOW TO BLUETOOTH
PAIRING THE CELL
PHONE.
1)
Activate Bluetooth
on
your
cell phone.
2)
Search for Bluetooth devices
around
you in
the
Blue tooth window.
3) After a while, you will search the
"STEALTH"
in
the
Bluetooth window of
your
cell
phone. If
"STEALTH"
don't
search, after placing the position of
the
vehicle key to
OFF,
try again in
ACC
after a while
4) Touch
the
"Stealth".
Wait
a
minute
and
it
will
be
connected
with
Mini Amplifier
of
ST4.1000DB.
5) Play
music
from
your
cell
phone.
6)
Never
operate
cell
phone
while
the
vehicle
driving.
~NOTICES
FOR USING BLUETOOTH
•
To avoid problems when connecting
your
device to
another
device, place
the
devices close to each other.
•
Ensure
that
your
device
and
the
other
Bluetooth device are within the Bluetooth
connection range(
10m). The distance may vary depending
on
the environment
the
devices are used in.
•
Ensure
that
there are no obstacles between
the
headset
and
a connected device,
including
human
bodies, walls, corners,
or
fences.
·Do
not
touch
the
Bluetooth
antenna
of a connected device.
•
Bluetooth uses the same frequency as some industrial, scientific, medical,
and
low
power products
and
interference may occur when making connections
near
these
types
of
products.
·Some
devices, especially those
that
are
not
tested
or
approved
by
the
Bluetooth
SIG,
may be incompatible with
the
headset.
•
Do
not
use
the
Bluetooth feature for illegal purposes (for example, pirating copies
of
files
or
illegally tapping communications for commercial purposes).
~
MOUNTING
THE AMPLIFIER
To
keep
your
MICRO
MINI
amplifier running
at
top
performance, choosing
the
proper
location it of utmost importance. For this reason
the
amplifier should
be
mounted in a location which will allow air to circulate freely. A clearance
of
at
least
2 -inches ( 5 em) to all sides
of
the amplifier
is
necessary
not
only for
proper
cooling,
but
also for gaining access to the inputs
and
other
variable controls.
Be
sure
that
the
power
and
signal cable connections can
enter
and
leave
the
amplifier in a straight
line to avoid the risk of kinked wires causing a malfunction.
~MOUNTING
LOCATION
Your
MICRO
MINI
amplifier comes with mounting feet that need to be attached to the amplifier
prior to installation.
Once
the feet are in place, use the amplifier as a template and mark the
four screw locations.
Use
caution to make sure there are no objects behind the installation
surface that may become damaged during drilling.
The amplifier should be protected from exposure to moisture and direct sunlight. The best
places to mount your amplifier are: The floor
of
the trunk, under the driver's seat,
or
on the
back
of
the rear seat. For alternate installation locations, please consult your dealer.
4
To Next Page
Loading...
Need help?
General
