Need help?Do you have a question about the Soundstream LW2.240 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power @ 4 Ohms | 40W x 2 |
| RMS Power @ 2 Ohms | 60W x 2 |
| Bridged RMS Power @ 4 Ohms | 120W x 1 |
| Minimum Speaker Impedance | 2 Ohms |
| THD @ RMS Output | <0.05% |
| Signal to Noise Ratio | >90dB |
| Damping Factor | >100 |
| Input Sensitivity | 200mV-6V |
| Crossover Frequency | 50Hz-500Hz |
| Crossover Slope | 12dB/Octave |
| Bass Boost | 0-12dB |
| Bass Boost Frequency | 45Hz |
| Fuse Rating | 20A |
| Low Pass Filter | 50Hz-500Hz |
| High Pass Filter | 50Hz-500Hz |
Key steps and precautions for amplifier installation, including wiring and cable routing.
Troubleshooting steps for when the amplifier produces no audio output.
Steps to diagnose and fix issues with the amplifier not powering up.
Steps to address amplifier overheating or protection mode activation.
To Next Page