8
1. LINE IN (RCA)
The RCA style input jacks are for use with source units that have RCA line level
outputs.
A source unit with a minimum of 250mV is required for proper operation.
However, this input will accept levels up to 6Vrms.
2. High Level Input
If you are installing by using a high level . you do not need to connect to the
remote. To hear a better sound quality, you must connect the high level ground
wire to the head-unit ground.
3. Thru-Out
The LINE OUT allows you to build multiple amplifiers systems without having to
use splitter cords to distribute the signal. Now it is simply a matter of bringing one
set of RCAS into the fist amplifier, then using the line out RCA jacks as the feed to
the next amplifier.
4. Remote Bass Boost Control
This control adjusts the Bass Boost gain for the amplifier
*Packed product can be different from the photograph.
5. SPEAKER Coneector.
As shown in the wiring diagrams, be sure to observe speaker polarity through the
system and speaker impedance. This specially tooled terminal is designed to
accommodate p to 18 gauge speaker wire.
6. FUSE
For convenience all A STEALTH Series amplifiers utilize common automotive ATC
type fuses. For continued protection in the event that a fuse blows, replace the fuse
only with the same value.
7. Power Input Connector
This terminal is the main power input for the amplifier and must be connected
directly to the positive (+) terminal of the car battery.
8. Remote (Remote Input Connection)
All STEALTH Series amplifiers can be turned on by applying 12 volts to this
terminal. This can be found on the rear of the source unit in the form of an electric
antenna output, or a remote output.
If this is not available you can wire to the ACC position on the key. An 18 gauge
wire is sufficient to run the REMOTE.
9. GND (Ground Input Connection)
A good quality ground is required for your STEALTH Series amplifier to operate at
peak performance.
A short length of cable the same gauge as your power cable should be used to
attached the ground terminal directly to the chassis of the vehicle.
To Next Page
Loading...
Need help?
General
