29
Chapter 5 Function parameter
5-1.Menu grouping
Note:
“★”: In running status, can not modify the parameter setting
“●”: The actual testing data, can not be modified
“☆”: In stop and run statuses, both can be changed;
“▲”: “Factory parameter”, no change about it.
“_” means the factory parameter is related to power or model. Please check the details in the
involved parameter introduction.
Change limit refers to whether the parameters are adjustable.
y0.01 is used for parameters protection password. Parameter menu can be enter into only after
inputting the right password in the function parameter mode or user change parameter mode. When
the y0.01 set to 0, the password is canceled.
Parameter menu is not protected by password under user customized parameters mode.
F group is the basic function parameters, E group is to enhance function parameters, b group
is a function of motor parameters,d group is the monitoring function parameters.
Monitoring function group
Monitoring frequency, current, etc
Frequency setting, control mode, acceleration and
deceleration time
Analog and digital input functions
Analog and digital output functions
Start and stop control group
Start and stop control parameters
Vector control parameters
Vector control parameters
To set key and display function parameters
To set Jog, jump frequency and other auxiliary
function parameters
To set fault and protection parameters
Communication parameter group
To set MODBUS communication function
Torque control parameters
To set parameters under torque control mode
Control optimization parameters
To set parameters of optimizing the control performance
Special application parameter settings
Wobbulate, fixed-length and
counting
To set Wobbulate, fixed-length and counting function
parameters
Multi-stage command, simple PLC
Multi-speed setting, PLC operation
To set Built-in PID parameters
Virtual I/O parameter setting
To Next Page
Loading...