Sourcetronic ST600-200G3 - Maintenance and Component Replacement; Scrap Treatment

Frequency Inverter ST600 Series High-Performance Multifunction VFD Safety Precautions
-4-
1.4.3 Maintenance and component replacement
⚫ Only well-trained and qualified professionals are allowed to perform maintenance,
inspection, and component replacement on the VFD.
⚫ Disconnect all the power sources applied to the VFD before terminal wiring, and wait
for at least the time designated on the VFD after disconnecting the power sources.
⚫ Take measures to prevent screws, cables and other conductive matters from falling into
the VFD during maintenance and component replacement.
Note:
⚫ Use a proper torque to tighten the screws.
⚫ Keep the VFD and its parts and components away from combustible materials during
maintenance and component replacement.
⚫ Do not carry out insulation voltage-endurance test on the VFD, or measure the control circuits of
the VFD with megameter.
⚫ Take proper anti-static measures on the VFD and its internal parts during maintenance and
component replacement.
1.4.4 Scrap treatment
The heavy metals inside the VFD should be treated as industrial effluent.
When its life cycle ends, the product should enter the recycling system. Dispose of it
separately at an appropriate collection point instead of placing it in the normal waste stream.