SousVideTools VS520-P - Vacuum Bags Care; Accessories Care; Storing Your Vacuum Sealer; Troubleshooting

7
The foam gaskets around the vacuum chamber should be dried thoroughly before re-assembling, when re-
assembling, is careful to prevent any damage, and assemble as original position to ensure no vacuum leaking.
Vacuum Bags
1 Wash bags in warm water with a mild dishwashing soap
2 When wash bags in dishwasher, turn bags inside out and spread them over top rack of dishwasher, so entire
surface is exposed to the washing water.
3 Dry thoroughly before reusing.
4 Toavoidpossibleillness,donotreusebagsafterstoringrawmeats,rawshorgreasyfoods.Donotreuse
bags that have been microwaved or boiled.
Accessories
Washing all vacuum accessories in warm water with a mild dishwashing soap, but don't immerse cover in water.
1 Canister bases (not lids) are top rack dishwasher safe. Canister cover should be wiped down with a damp cloth.
2 Ensure the accessories is dried thoroughly before reusing.
3 Do not use Canister or cover in the microwave or freezer.
Storing Your Vacuum Sealer
1 Keeptheunitinaatandsafeplace,outofthereachofchildren.
2 Make sure the lid of appliance is unlocked when not in use and in storage. Keeping the cover locked will distort
the foam gaskets which could cause leaking.
TROUBLESHOOTING
Error
The Vacuum
Sealer does not
pull a complete
vacuum or seal
automatically
Check if the bag open mouth is totally inside the chamber.
Check if the gasket is loose.
Check if for any particle on the seal foam or gasket, is the seal foam properly assembled.
Check if the lid is locked.
Check if there is leakage in the bag. Check by putting the bag into water, press the bag, if
there are bubbles then there is leak. Change bag.
Fail to seal The machine may have over run. Rest the machine between cycles. The break should
be at 20 seconds between every seal.
Any wrinkles, grease, liquid or other debris on the open end of the bag will cause an
issue. Try a new clean bag.
There may be moisture or debris on the sealing bar. Clean the bar, and seal again.
Vacuum bag
loses vacuum
after being
sealed
Any wrinkles, grease, liquid or other particles on the seal could cause this issue, please
open the bag, clean the bag mouth and vacuum again.
Check if there is any moisture or liquid on the food, if yes, open the bag and vacuum
again, or change to a new bag. If the food is juicy it is suggested you consider freezing
before vacuum.
Error Troubleshooting
Machine not
working
Ensure the machine is plugged in.
Check the power cord for tears and frays.