To setup the analog out:
1) Hold the (Set Button) for 5 seconds Passcode Screen will pop up
2) Press the (Set Button) one time to activate data entry, enter (6557) using the (Up
and Down buttons)
3) Press the (ENT Button) to confirm the entry.
It will bring (Hold Set) Screen, press (NEXT) button to get to the analog output screen “4-20 out”,
Using the (up and down buttons) buttons to change type of sensor, to confirm press (Set button).
To exits menu press (Next button) to get back to main screen “running or standby”.
Note: Analog output for standard units (without advanced options) will only offer ambient
temperature signal, check appendix A.
To Next Page
Loading...
