South-Tek Systems N2-BLAST FPS-500 - 3 Receiving, Unpacking, and Storage Instructions; Unpacking and Preparation

P
The Leader in Nitrogen Generation Technology
FPS-500 O&M Manual
Revision 2; 3/2020
Page 8 of 30
3. Receiving, Unpacking, and Storage Instructions
3.1. UNPACKING AND PREPARATION
The N
2
-BLAST
®
FPS-500 will arrive in a cardboard box. Open the box carefully and identify and verify
all parts listed on the packing list are present and undamaged. South-Tek Systems (STS) is not
responsible for damages that occur during shipping and handling of the N
2
-BLAST
®
. Document any
visual damages and report them to the responsible shipping company, and then, contact STS at (888)
526-6284 to assess the damages.
Until Installation:
• Store the N
2
-BLAST
®
in a dry and climate controlled (60-80° F) room.
• Always keep N
2
-BLAST
®
in an upright position / or, preferably, in the box as shipped.
• Read entire manual and make all connections (per instructions) before connecting power.
• Keep all gas lines dry so moisture does not enter generator upon hookup.
• Never place/stack objects on top of the N
2
-BLAST
®
.
Remove the nitrogen generator from the cardboard box by carefully lifting the unit out and setting it on a
flat surface. Prepare the wall mounting bracket before moving it to the final location.
Note: Remove the 4 painted bolts below the cabinet to free up the compressor’s vibration isolators.
Carefully, break down the cardboard box and store in a safe location. Reuse the cardboard box if
returning for factory service.
Figure 1: Remove shipping bolts (x4)
Remove these 4
bolts underneath
the cabinet prior to
starting up the unit